[B]AssaultTech 1 BattleTech LowPoly Models[/B]
Clan names, bitch.
The Hellbringer is 1992 triangles.
The Summoner is 1838 triangles.
Both include the animation reference points for Sake906, so they're from 40-100 triangles less in terms of visible detail.
The elbow on the Hellbringer's arms (Summoner's right arm), are done in a hinge, as it's the only thing that actually looked good without looking like shit at the same time, and it allows the arm to at least swing out at that point.
To be honest, the Hellbringer is just barely shorter in this picture, honestly, since they share the same leg structure and have comparable size torso's, that's understandable, besides, there's only a 5 ton difference between them (Summoner 70 tons, Hellbringer 65 tons).
These will be used to replace the currently lacking (due to age) models made by team members who are no longer working with the project. Higher detail models while still within the polycount limits set for the game (not too high, not too low).
Comments
Atlasfield Says:
I played my old Mechwarrior 2 I remember the names of the battlemech... I wish see again the incubus and orned owl... and jenner of course
. However, I prefer the Atlas, slow worse than a turtle but is very strong, pretty difficult by eliminate. X)
However, I feel homesick for my old games... I need back!